Search...
Menu

Install and connect configuration software

RxControl:

Allows you to configure Onertk Pro and monitor receiver data by visualizing available satellites and their signals. Analyze GNSS activity using graphs such as signal-to-noise ratio, sky map, position map, 3D orientation visualization, time plot, and more.

 

Software usage tutorial:

Download and install RxTools software,Download Link

Install directly after downloading to avoid Chinese characters in the installation directory. After the software is successfully installed, there will be the following assembly:

 

 

Hardware Hookup

  1. Connect the module to the antenna
  2. The RTK module is connected to the computer using a type-c data cable
  3. Check the ports on the computer device management interface. Normally, two ports will be generated as shown below:
  4. If two ports are not displayed, download and install the driver,Download Link

 

Link RxControl

Start the RxControl software, and the Connection Setup dialog box will pop up. For the first connection, you need to create a new connection interface as follows:

  • Select Serial Connection → Select Create New… Click next

 

  • Select the generated port, select USB COM port 1 (COMXXX), fill in the connection Name://, you can name it as you like, and click Finish.

  • After the connection is successful, you can see the RxControl interface as follows
Previous
Module extension configuration
Next
View/record positioning data
Last modified: 2025-07-03Powered by