Product user manual

Product function

OneWLink is equivalent to a hot spot, a serial port connected to the flight control, and a computer or mobile phone connected to wifi can realize the communication between the drone and the ground station.

Wiring instructions

Connect TELEM1 or TELEM2 ports of flight control.

Use Ardupilot firmware

Flight control parameter configuration

For example, OneWlink connects to TELEM1 port of flight control. Flight control connects to the computer via type-C data cable,

Connect to the Mission Planner ground station, in the Configuration/Commissioning "All Parameters" table,

Search SERIAL1_BAUD, change the value to 921 (corresponding to the baud rate of 921600), point write parameters, flight control power off and restart.

Wireless communication link

The computer recognizes the wifi signal from the module, the wifi name is ZeroOneAero_xxx, and the connection password is zerooneaero

The mission planner ground station is automatically connected to flight control;

If there is no automatic connection, select port UDP point connection, enter port 14550, click ok.

Note: If you still can't connect, check if the firewall is blocking mission planner's wireless link communication

 

Use PX4 firmware

Flight control parameter configuration

For example, OneWlink connects to TELEM1 port of flight control. The flight control connects to the computer through the type-C data line and connects to the Qgroundcontrol ground station. The X6/X6 AIR flight control needs to manually add ports to connect.

Search for SER_TEL1_BAUD in parameters to change the baud rate to 921600, and the flight control power off and restart.

Wireless communication link

The computer recognizes the wifi signal from the module, the wifi name is ZeroOneAero_xxx, and the connection password is zerooneaero

Add a new PORT on Comm Links of QGC ground station, name arbitrary, TYPE UDP, and port 14550 by default.

Select port, point connection