OneVDLink R17 Configure Guide

Instructions for Use

1、The ground terminal is powered separately and connected to a rubber rod antenna via a feeder cable and a network cable.

2、Set the IP network segment of the computer to be the same as that of the ground terminal and the sky terminal. (The factory-set network segment will be labeled on the device)

3、Open the browser, search for the IP addresses of the ground terminal and the sky terminal respectively, and log in as an administrator

4、Successfully log in to the WebUI management tool to set the key. Note: The keys on the ground terminal and the sky terminal should be set to be the same.

5、Master-slave setup: Select the central contact point for the ground terminal and the access node for the sky terminal.

6、IP address setting: The network segments for all ground terminals and sky terminals must be the same, and the numbers between 168 and 112 must all be the same.

7、In wireless parameter settings, the frequency band setting involves choosing the corresponding frequency band based on the glue stick antenna used.

8、The SkyPort operates independently with a power supply of 18~53V and 10W. Its Ethernet port is connected to the flight controller's Ethernet port, and its serial port is connected to the flight controller's serial port. Open the MP ground station to connect to the flight controller. Open the full parameter table to search for NET_GWADDR0~NET_GWADDR3 to set the gateway IP. NET_IPADDR0~NET_IPADDR3 to set the flight controller IP. NET_P1_IP0~NET_P1_IP3 to set the computer IP. NET_P1_PORT to set the port number. NET_P1_PROTOCOL to set MAVLink. NET_P1_TYPE can be set to 1 by default